How to Install Shower Standing Handles

How to Install Shower Standing Handles

Elderly people who have difficulty getting into and out of the shower can greatly benefit from installing a shower standing handle. The CDC estimates that 3 million elders fall each year, with 37% of those accidents occurring in the bathroom. Older folks may find it difficult to get in and out of the shower if they don’t have a handle to hold onto. The various techniques for mounting the handles are shown in the following table.

Use of Suction Cups

People who cannot stand or walk can use shower standing grips to help them get in and out of the shower. Because of this, people with disabilities or lack of balance are less likely to slip and fall in the shower. These gadgets are installed using suction cups. There are no sharp corners or edges on these devices, making them easy to grip and use. Changing the height of the handles is as simple as removing the handles and reinstalling them.

Mounting Brackets

People who have trouble walking or standing up can benefit greatly from the assistance provided by shower standing handles. As an alternative to standard shower handles, these can be utilized to boost the stability and safety of the shower experience. Falls are also less likely with the use of these fixtures. It’s a good idea to install them in your shower if your safety or balance is an issue for you. Learn how to install these shower decorations on your own by reading on. You’ll find them helpful once they’ve been installed.

Screws

There is a variety of “standing” shower handles to choose from. Surfaces with a smooth, nonporous surface can be used to connect suction shower handles. Nonporous tiles are the norm. Keep the handle away from the grout line, and make sure you have a wide tile at the bottom of your wall to prevent it from shifting. Even screws hidden below the wall studs can be used to install the handles. To avoid a hole in your wall that is difficult to repair, make sure you secure them with screws.

Anchors

The first step in installing shower standing handles is to decide where the grasp bar will go. The handle should be secured to the tub edge rather than the wall if the bar is to be installed on the tub’s edge. Then, using a cordless drill and a masonry bit, make a small hole in the mark. After that, screw the anchor into place, being careful not to overtighten the screw.

Height

There is a broad variety of shower handles to pick from. While the average person prefers a 36-inch handle, taller folks may need one that is 43 inches high. Extra safety and balancing assistance are provided by Life Savers, a brand name for shower handles with grab bars. The mounting holes’ center-to-center distance is commonly used to calculate the handle’s height.

Health Risks

“Standing handles” in the shower are a helpful item for those who have difficulty ambulating. In the case of an accident, they provide additional stability and lessen the likelihood of a fall. People with impairments or a loss of balance can also benefit from their use. When it comes to installing shower knobs, here are a few things to keep in mind. Proper installation of these devices is required to avoid any potential risks.

The following safety advice will help you avoid some of the most prevalent hazards when installing your new shower stalls. Make sure there are no slippery surfaces in your bathroom. Keep the space clear of any loose debris, whether you’re installing a shower or a bath. A significant cause of falls is slippage, therefore install grab bars to prevent it. You can also use these gadgets to help you enter and exit the bath or shower. By installing hold bars, you can lessen your reliance on shaky ground.

Leave a Reply

Your email address will not be published. Required fields are marked *